Randy Ayers Nascar Modeling Forums

Sorry, I meant TS-36 fluorescent red the TS-23 is the petty blue.

I used TS-23 from Tamiya it’s the go to for all Petty STP cars.

second one from the front 0@00

I don't paint mine and it looks fine to me but I also put the window nets in, glue the hood shut and put them in a AMT plastic display case so all you see is the outside.

Google Plastic Performance Products, there are five or six dealers listed that sell PPP products.

George, It's a ACE sheet and Mikes has them under the ACE decal section, take a look at them I'm sure you will find it covers every possibility for the Chargers and the Daytona as well. John.

I have had good luck with just putting the plastic in the freezer for an hour or so and it will break apart, then clean it up and re-glue.

I have one you can have, PM your address and I'll get it out to you tomorrow. John.

These guys raced three sometimes four nights a week back then with the same car, not much time for body work.

Thank you Thomas for bringing back a memory of a car that raced five miles from were I live. The ASA races at Cayuga in the1980's were the greatest memory's I have of short track racing. Thanks again, ...

Don't rinse with water until after you have brushed the graphics off, the water kills the alcohol. I forgot to mention I'm Canadian and they sell 99% alcohol in most pharmacy's here but I've used 91% ...

99% isopropyl alcohol, let it soak for 3 or 4 hours then use a soft brush like a old tooth brush, if you get a stubborn spot dip the brush in the alcohol and scrub a little more. I have done this at l ...

Anybody looking for a flat hood for the 71-72 . Harts Parts Resin sells a flat hood for the 72 MPC Charger, I've used his stuff for years and it's great.

PM sent

Thank you AdamtheWayne, I've been lurking around here since 2009 and I went by johnnyk before the forum went down. I have finally been inspired to post a reply. I never heard of Justin Bieber before h ...